By: helene on Aug. 22, 2023, 9:05 a.m.
Hello!
I wanted to ask about the results of the subtask. If I look at the measurements, it is evident that something went completely wrong. I cannot reproduce this on my side. Just out of curiosity, I'd like to understand what happened. Do you have any idea?
Best, Helene
By: apepe on Aug. 23, 2023, 3:52 p.m.
Dear Helene,
There was indeed an issue. You submission failed to generate a valid mesh for three cases. The reason is that the surface mesh was not watertight for these cases. As this condition was not satisfied, the system assigned the default value -100.
It would be interesting to read about your solution in a paper if you are planning to submit one.
Best, Antonio
